Load Default Bios Settings Jumper (J44); Always On Jumper Setting (J10); Table 42: Jumper Description J10; Figure 32: Available Cable Kit, Break-Out-Board - Kontron mITX-BW User Manual

Figure 32: Available cable kit, Break-Out-Board:

PN 1052-5885 Cable, Feature 44pol 1 to1, 300 mm

7.15. LOAD DEFAULT BIOS SETTINGS Jumper (J44)

The "Load Default BIOS Settings" Jumper (J44) can be used to recover from incorrect BIOS settings.
As an example, an incorrect BIOS setting which causes the attached display not to turn on can be erased by this
Jumper. The Jumper by default is in open position.

Figure 33: LOAD DEFAULT BIOS SETTINGS Jumper (J44)

7.16. ALWAYS ON Jumper Setting (J10)

Figure 34: ALLWAYS ON Jumper (J10)

Table 42: Jumper Description J10

J10 position
Pin 1-2 Pin 2-3
X -
- X
X = Jumper is set
Description
ALWAYS ON feature enabled
Board will power up, when the external power supply is switched on
ALWAYS ON feature disabled
Board will not power up, when the external power supply is switched on
Activate the power on button (PWRBTN_IN#) at the Front Panel connector (FRONTPNL)
in order to switch on the board.
www.kontron.com
PN 820978 Feature BOB (Break-Out-Board)
J44
Pin 1
mITX-BW – User Guide, Rev. 1.6
// 47