KTD-N0903-C
Always On connector (Always On - J36)
7.13
The "Always On" can be used to implement hardware controlled Always ON by jumper. When "Always On" is
selected, then the board will power up automatically when power is connected. It doesn't matter if "Always
On" is not selected in BIOS.
The board can still be shut down by PWRBTN_IN# (power button in) activation (via Front Panel connector).
Always On
pin1-2
pin2-3
X
-
-
X
-
-
Page 35
Pin 1
Description
Always On selection
Default position
No function. Note: may load default BIOS settings after several minutes
mITX-E38 Users Guide
Internal Connectors