Removing And Installing Ball Thrust Bearing - BMW R 1200 C Repair Manual

Removing and installing ball thrust bearing

1
•
Remove retaining ring (1).
•
Heat fork bridge to 100 °C (212 °F).
•
Remove ball thrust bearing, if necessary striking
lightly with a plastic-faced hammer.
•
Press out the threaded journal using a pin,
BMW No. 31 5 651, as a support.
•
Press the threaded journal into the ball thrust
bearing using a pin, BMW No. 31 5 651, as a
support.
C310050
•
•
31 5 651
GS310110
31 5 651
GS310120
31 5 653
Heat the fork bridge to 100 °C (212 °F) and press
in the ball thrust bearing with pin,
BMW No. 31 5 651, and bushing,
BMW No. 31 5 653.
Install retaining ring.
31 5 651
C310060
31.7