10.10
Adjusting the spring preload of the shock absorber
Caution
Risk of injury Parts of the shock absorber will move around if the shock absorber is detached incor-
rectly.
The shock absorber is filled with highly compressed nitrogen.
–
Please follow the description provided. (Your authorized Husqvarna Motorcycles workshop will be
glad to help.)
Info
Note the current adjustment before changing the spring preload - e.g. measure the spring length.
Preparatory work
–
Remove the right side panel. (
–
Remove main silencer. (
–
Raise the motorcycle with a lift stand. (
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
Main work
–
Loosen screw
–
Turn adjusting ring
sion.
Hook wrench (90129051000)
Info
If the spring cannot be fully released, the spring must
be removed to accurately measure the spring length.
–
Measure the total spring length while the spring is not under
tension.
–
Tension the spring by turning adjusting ring
A
dimension
Guideline
Spring preload
Info
F03627-10
Depending on the static sag and/or the riding sag, it
may be necessary to increase or decrease the spring
preload.
–
1
Tighten bolt
Guideline
Screw, shock
absorber adjusting
ring
Finishing work
–
Install the shock absorber.
–
Install the right side panel. (
–
Check the free travel of the foot brake lever. (
TUNING THE CHASSIS 10
p. 52)
p. 68)
p. 48)
(
p. 60)
1
.
2
until the spring is no longer under ten-
.
8 mm (0.31 in)
.
M5
5 Nm (3.7 lbf ft)
(
p. 61)
p. 52)
2
to specified
p. 88)
41