Adjusting The Spring Preload Of The Shock Absorber - Husqvarna 250 XC TPI 2021 Owner's Manual

10.10

Adjusting the spring preload of the shock absorber

Caution
Risk of injury Parts of the shock absorber will move around if the shock absorber is detached incorrectly.
The shock absorber is filled with highly compressed nitrogen.
–
Please follow the description provided. (Your authorized KTM workshop will be glad to help.)
Info
Before changing the spring preload, make a note of the present setting, e.g., by measuring the spring
length.
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
Main work
–
Loosen screw
–
Turn adjusting ring
sion.
Hook wrench (90129051000)
–
Measure the total spring length while the spring is not under
tension.
–
Tension the spring by turning adjusting ring
A
dimension
Guideline
Spring preload
Info
Depending on the static sag and/or the riding sag, it
may be necessary to increase or decrease the spring
preload.
–
Tighten screw
402659-10
Guideline
Screw, shock
absorber adjusting
ring
Finishing work
–
Install the shock absorber.
–
Remove the motorcycle from the lift stand. (
TUNING THE CHASSIS 10
p. 47)
( p. 56)
1
.
2
until the spring is no longer under ten-
.
7 mm (0.28 in)
1
.
M5 5 Nm (3.7 lbf ft)
( p. 57)
2
to specified
p. 47)
41