Table of Contents
Advertisement
16
TUNING THE ENGINE
16.7
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
0 0 0
16.8
Adjusting the basic position of the shift lever
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and/or death.
–
–
Allow the vehicle to idle.
The MIL stops flashing once teaching is completed.
401897-01
Info
If the engine becomes too hot, perform a cool-down ride at medium revs.
Then do not switch off the engine after this, but leave it running at idle
speed until teaching is completed.
–
Sit on the vehicle in the riding position and determine distance
upper edge of your boot and the shift lever.
Distance between shift lever and
upper edge of boot
»
If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
400692-10
–
Remove screw
401950-12
–
Clean gear teeth
–
Mount the shift lever on the shift shaft in the required position and engage the
gearing.
Info
The range of adjustment is limited.
The shift lever must not come into contact with any other vehicle compo-
nents during the shift procedure.
–
Locate and tighten screw
401951-10
Guideline
Screw, shift lever
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without
an effective exhaust extraction system.
with washers and take off shift lever
of the shift lever and shift shaft.
with washers.
M6
between the
10... 20 mm (0.39... 0.79 in)
(
p. 81)
.
14 Nm
Loctite
(10.3 lbf ft)
81
®
243™
Advertisement
Table of Contents
