Table 6: Alarms That Can Trigger Output Dry Contacts - Gamatronic CENTRIC 50 kW User Manual

G E I L .
AMATRONIC LECTRONIC NDUSTRIES TD

Table 6: Alarms that can trigger output dry contacts

(The messages are listed here in alphabetic order)
Ac input failure
Ac input voltage high
Ac input voltage low
Actual responding modules are less than defined
Adapter (PC710) not responding
All UPS modules not responding
Auxiliary #1 fault
Auxiliary #2 fault
Auxiliary #3 fault
Auxiliary #4 fault
Auxiliary #5 fault
Battery failed last test
Battery test in progress
Conflict with the nominal output voltage and/or frequency
Controller battery test failed
Dc voltage high
Dc voltage low
Detected modules are more than defined
Emergency Power Off is active
End of battery backup, battery discharged to shutdown limit
Fan failure
High load level
Load is now running on bypass
Low battery voltage
More than one module is sending an alarm or warning
No ac output to load
No output current at one or more modules because of fault
Overload current
Static switch is not responding
Static switch is sending alarm or warning
Sync fault
System active
Temperature fault
The system is operating with more than one master
UPS module #1 is sending an alarm or warning
UPS module #2 is sending an alarm or warning
UPS module #3 is sending an alarm or warning
UPS module #4 is sending an alarm or warning
UPS module #5 is sending an alarm or warning
UPS module #6 is sending an alarm or warning
UPS module #7 is sending an alarm or warning
UPS module #8 is sending an alarm or warning
UPS shutdown by "Off" button on LCD panel
62 CENTRIC User Guide, rel. 3.4