Table 4: Alarms That Can Trigger Output Dry Contacts - Gamatronic Centric 50 kVA User Manual

The alarm conditions are listed in Table 4.
System active
Emergency Power Off is active
UPS shutdown by "Off" button on LCD panel
UPS shutdown by hardware "Off" button
UPS shutdown by remote user command
UPS shutdown by end of battery backup
UPS shutdown by overload
UPS shutdown by Emergency Power Off
Static switch is not responding
Adapter (PC710) not responding
All UPS modules not responding
Controller battery test failed
The system is operating with more than one master
Detected modules are more than defined
Actual responding modules are less than defined
Conflict with the nominal output voltage and/or frequency
UPS module #1 is sending an alarm or warning
UPS module #2 is sending an alarm or warning
UPS module #3 is sending an alarm or warning
UPS module #4 is sending an alarm or warning
UPS module #5 is sending an alarm or warning
UPS module #6 is sending an alarm or warning
UPS module #7 is sending an alarm or warning
UPS module #8 is sending an alarm or warning
More than one module is sending an alarm or warning
No output current at one or more modules because of fault
Fan failure
Dc voltage high
Dc voltage low
Low battery voltage
End of battery backup, battery discharged to shutdown limit
Temperature fault
Battery test in progress
Battery failed last test
Load is now running on bypass
Static switch is sending alarm or warning
Sync fault
Ac input voltage high
Ac input voltage low
CENTRIC User Guide, Release 0.3
Gamatronic Electronic Industries Ltd.

Table 4: Alarms that can trigger output dry contacts

49