Using The Command And Response Tables - Extron electronics FOXBOX Tx HDMI User Manual

Error Responses
When the unit receives a valid SIS command, it executes the command and sends a
response to the host device. If the switcher is unable to execute the command because the
command is invalid or it contains invalid parameters, the transmitter or receiver returns an
error response to the host. The error response codes are:
E10 - Invalid command
E11 - Invalid preset number
E13 - Invalid parameter
E14 - Invalid command for this configuration
Timeout
Pauses of 10 seconds or longer between command ASCII characters result in a timeout.
The command operation is aborted with no other indication.

Using the Command and Response Tables

The command and response tables begins on the next page. Symbols are used
throughout the table to represent variables in the command and response fields. Command
and response examples are shown throughout the table. The ASCII to HEX conversion table
below is for use with the command and response table.
ASCII to Hex Conversion Table
Space
•
FOXBOX Tx/Rx HDMI • Remote Control 20