Installation - Extron electronics FOXBOX Tx HDMI User Manual

Installation

This sections details the installation of the FOXBOX Tx/Rx HDMI, including:
•
•
•
Installation Overview
Follow these steps to install and set up an Extron FOXBOX HDMI transmitter and receiver
system for operation:
1.
2.
3.
4.
Connections
Transmitter Connections, Controls, and Indicators
POWER
12V
1.0A MAX
FOXBOX Tx HDMI Rear Panel
Figure 2.
A
C
E
G
I
K
A
B
Installation Overview
Connections
Operation
Turn off all of the equipment. Ensure that the video sources and the output display are
all turned off and disconnected from the power source.
Mount the transmitter and one or more receiver (see
Connect the cables and configure the receivers (see "Connections," below).
Plug in the power supplies, then turn on the display devices and the input devices.
J J A A C C D D E E
FOXBOX Tx HDMI
RS-232
OVER FIBER ALARM
AUDIO INPUT Tx Rx 1 2
HDMI INPUT
FOXBOX Tx Transmitter Connectors
HDMI Input connector (see below)
Audio connector (see the
Alarm outputs port
EDID Minder switch (see
Configuration port
Indicators
HDMI Input connector (FOXBOX HDMI only) — Connect a single link of HDMI or
DVI-D (with the appropriate adapter) to this HDMI connector (see
page 12).
The FOXBOX Tx HDMI also accepts embedded digital audio on this connector.
HDMI Loop-through connector — If desired, connect a local monitor to this HDMI
connector.
Mounting the Unit
F F K K
Tx Rx
CONFIG
OPTICAL
Front Panel
HDMI Loop-through Connector
B
next page) RS-232 Over Fiber port
D
Fiber optic connectors
F
page 8) DIP switches
H
DC power connector
J
FOXBOX Tx/Rx HDMI • Installation
on page 42).
I I F F G G B B
HDMI LOOP THRU
50Hz DIGITAL
EDID MINDER
AUDIO
FOXBOX Tx HDMI
60Hz ANALOG
page
(see
HDMI connector
7)
on
5