Extron electronics FOXBOX Tx HDMI User Manual page 16

EDID Minder switch (see
G
below to select the source of the DDC or a specific resolution.
Position 0 — A user-recorded EDID that has been captured from the display
connected to the HDMI loop-thru connector on the transmitter (item
page 5) or manually imported via an
Position 1 — The EDID is selected via the front panel Configuration port using an SIS
command or the FOX Extenders Control Program.
Position 2 - F — Specify a resolution. The table below identifies the switch positions
and the associated resolutions.
Pos. Source or resolution
0 User recorded EDID
1 RS-232
2 800x600
3 1024x768
4 1280x720 (720p)
5 1280x768
DIP switches —
H
50 Hz / 60 Hz switch — This switch selects the vertical refresh rate of the
resolution selected by the EDID Minder hex switch
page 5). Up selects the 50 Hz rate and down selects the 60 Hz refresh rate.
Audio switch — This switch selects which audio input, the audio embedded in
the HDMI input or the analog audio, is sent to the receiver. Up selects the digital
(embedded) audio and down selects the analog audio.
Configuration port — Connect a controlling device, such as a PC, to this port
I
via a 2.5 mm mini jack TRS RS-232 cable for RS-232 protocol control of all
FOXBOX functions. See
on the adapter cable. See
software control.
The TRS RS-232 cable is included with the FOXBOX Tx HDMI transmitter.
DC power connector
J
into this connector. See
Indicators
—
K
Power LED — T his LED lights to indicate that power is applied to the unit .
HDMI LED — This LED lights when the transmitter detects an input signal on its video
input.
HDCP LED — This LED lights when the input signal is HDCP encrypted.
Audio LED — This LED lights when the transmitter detects a low level audio signal for
a short period of time on the selected (embedded or analog) input. It returns to unlit if
the audio signal drops below the minimum threshold for a short period of time.
figure 2 on page 5)— Set this switch to one of the positions
SIS command
Pos. Resolution
6 1280X*00
7 1280x1024
8 1360x768
9 1366x768
A 1400x1050
B 1440x900
Front panel Configuration ports
Remote Control on page 18 for SIS commands and
— Plug the included external 12 VDC power supply
Power supply wiring on page 15, to wire the connector.
FOXBOX Tx/Rx HDMI • Installation
on figure 2
B
on page 22 to the transmitter.
Pos. Resolution
C 1600x1200
D 1680x1050
E 1920x1080 (1080p)
F 1920x1200
(item on figure 2 on
G
on page 14 for more details
on
50Hz DIGITAL
AUDIO
60Hz ANALOG
CONFIG
POWER
12V
1.0A MAX
8