Error Responses; Using Command And Response Tables For Sis Commands - Extron electronics XTP SR HDMI User Manual

Error Responses

When the XTP SR HDMI receives an SIS command and determines that it is valid, it
performs the command and sends the corresponding response to the host device. If the
command is determined invalid or contains invalid parameters, the receiver returns an error
response to the host. The error response codes are:
= Invalid command
E10
= Invalid preset number
E11
= Invalid parameter
E13
= Not valid for this configuration
E14
= Invalid command for signal type
E17
= Busy
E22

Using Command and Response Tables for SIS Commands

command and response tables
The
hexadecimal equivalent of ASCII characters used in the command and response tables.
NOTE: Uppercase and lowercase text can be used interchangeably unless otherwise
stated.
Space
Figure 17.
ASCII to Hex Conversion Table
ASCII to Hexadecimal Conversion
XTP SR HDMI Scaling Receiver • SIS Configuration and Control
begin on page 23. Figure 17 shows the
•
21