Status Requests - Extron electronics FOXBOX Tx HDMI User Manual

Command and Response Table for Transmitter SIS Commands (continued)
Command Function

Status requests

View link 1 (Tx-to-Rx) status
View link 2 (Rx-to-Tx) status
View input video status
View input audio status
View all signal status
View HDMI signal status
View HDCP status
View temperature
Information requests
Information request
Show firmware version
Example:
Request part number
Input sync detection
Resets
Reset audio
System reset
: X1@
KEY = Link and input status
X1#
= Internal temperature
X1$
= Transmission mode
X1%
= Firmware version
X1&
= Sync frequency
SIS Command Response
(Host to Unit) (Unit to Host)
X1@]
1S
X1@]
2S
X1@]
3S
X1@]
4S
5S
SigI
6S
SigI
7S
HdcpI
X1#
20S
I
1Lnk
X1%]
Q
Q
1.23
N
60–nnnn–nn
X1&
1LS
E }
ZA
Zpa
E }
ZXXX
Zpx
0 = link or input not detected
nnnF • nnC
SM = singlemode
v . vv
. (frequency in kHz [H] or Hz [V])
xxx xx
Additional description
X1@ X1@ X1@
• • •
SigO HdcpI HdcpO
Report the status of the HDMI input,
HDMI output, HDCP encoding on the
input, and HDCP encoding on the
output.
X1@ X1@]
Report the status of the HDMI input
•
SigO
and HDMI output (always -- for a
transmitter).
X1@ X1@]
Report the status of the HDCP
•
HdcpO
encoding on the input and HDCP
encoding on the output.
X1# ]
Show temperature in degrees
•
F C
Fahrenheit and Celsius.
X1@ X1@ X1@ X1@ X1$
• • • •
2Lnk Vid Aud
The unit responds with the current
status (signal detected) of optical
link 1, optical link 2, the video input,
and the audio link; the fiber optic
transmission mode (singlemode or
multimode); and the device type (Tx).
]
The factory-installed firmware version
is 1.23 (sample value only).
]
X1& ]
Shows horizontal frequency in kHz and
,
horizontal vertical
vertical freq in Hz. 000.0,000.0 if no
signal is detected.
]
Reset audio setting to default levels
(0 dB gain).
]
Reset all settings to factory defaults.
1 = link or input detected
MM = multimode
FOXBOX Tx/Rx HDMI • Remote Control
X1@]
]
•
Tx
23