Receiver Connections, Controls, And Indicators - Extron electronics FOXBOX Tx HDMI User Manual

Receiver Connections, Controls, and Indicators

Rear panel
S S
POWER
12V
1.0A MAX
Figure 4.
HDMI Input connector (see below)
L
Audio connector
N
Alarm outputs port
P
Remote RS-232 port
R
HDMI Output connector — Connect a video display to this HDMI connector (see
L
HDMI connector
HDMI Audio switch — This switch mutes (Off position) and unmutes (On position) the
M
embedded audio output on the HDMI output connector. The audio on the captive screw
output always remains active regardless of the setting of this switch.
Audio output connector — This 5-pole, 3.5 mm captive
N
screw connector outputs the transmitted, unamplified, line level audio.
Connect audio devices, such as an audio amplifier or powered speakers.
See Audio output connector
connector for the appropriate output type and impedance level.
RS-232 Over Fiber port — If you want the FOXBOX to pass serial
O
command signals to a slave device, for serial control of a projector for
example, connect the slave device to the receiver via the first three leftmost
poles (Tx, Rx, and
connections
NOTES:
•
•
Alarm outputs port — For remote monitoring of the status of fiber optic
P
link 1, connect a locally-constructed or furnished monitoring device to the
receiver via the two rightmost poles (1 and 2) of this 5-pole captive screw
connector. When the receiver does not detect a light link on fiber cable Rx,
pin 1 and pin 2 of this port are shorted together (see
page 13 to wire this connector).
Q Q
Tx Rx
HDMI AUDIO
FOXBOX Rx HDMI
OPTICAL
FOXBOX Rx Receiver Rear Panel Features
(see page 11)
on page 12).
on page 14 to wire a captive screw
_
) of this 5-pole captive screw connector. See
on page 13 to wire this connector.
If you connect only one fiber optic cable
configure the receiver for daisy-chaining, you will not receive reports from the
controlled device. To receive responses from the controlled device, you must
install two fiber optic cables and leave link 2 enabled (via an
(see page 25) to the receiver or using the
(see page 34).
The FOXBOX can pass RS-232 commands and responses at rates up to
115200 baud.
M M L L N N
OUTPUTS
AUDIO
L R
ON
HDMI
OFF
HDMI Loop-through Connector
M
RS-232 Over Fiber port
O
Fiber optic connectors
Q
DC power connector
S
(item , on the next page), or you
Q
FOX Extenders Control Program
Alarm outputs connection
FOXBOX Tx/Rx HDMI • Installation
O O P P R R
RS-232 REMOTE
OVER FIBER ALARM RS-232
Tx Rx 1 2 Tx Rx
(see page 10)
AUDIO
L R
RS-232
OVER FIBER ALARM
Tx Rx 1 2
RS-232
SIS command
RS-232
OVER FIBER ALARM
Tx Rx 1 2
on
9