Information Requests - Extron electronics FOXBOX Tx HDMI User Manual

Command and Response Table for Receiver SIS Commands (continued)
Command Function

Information requests

Information request
Show firmware version
Example:
Request part number
Input sync detection
Resets
Reset audio
System reset
X1@
KEY: = Link status
X1$
= Transmission mode
X1%
= Firmware version
X1&
= Switch position
SIS Command Response
(Host to Unit) (Unit to Host)
I
1Lnk
X1%]
Q
Q
1.23
N
60–nnnn–nn
X1&
1LS
E }
ZA
Zpa
E }
ZXXX
Zpx
= light or signal input not detected
0
= light or signal detected
1
= singlemode
SM
.
v vv
= off (right)
0
Additional description
X1@ X1@ X1@ X1@ X1$
• • • •
2Lnk Vid Aud
The unit responds with the current
status (signal detected) of optical
link 1, optical link 2, the video input,
and the audio link; the fiber optic
transmission mode (singlemode or
multimode); and the device type (Rx).
]
The factory-installed firmware version
is 1.23 (sample value only).
]
X1& ]
Shows horizontal frequency in kHz and
,
horizontal vertical
vertical freq in Hz. 000.0,000.0 if no
signal is detected.
]
Reset audio setting to default levels
(0 dB gain).
]
Reset all settings to factory defaults.
= multimode
MM
= on (left)
1
FOXBOX Tx/Rx HDMI • Remote Control
]
•
Rx
27