Extron electronics FOXBOX Tx HDMI User Manual page 42

Plus Mode Transmission panel
NOTE: The
Plus Mode Transmission
only if you are connected to the transmitter.
The
Plus Mode Transmission
Plus mode enabled forces the transmitter to emulate a FOXBOX DVI Plus or
PowerCage FOX DVI Plus transmitter for compatibility with one of four receivers:
a FOXBOX HDMI Rx, a FOXBOX DVI Plus Rx, a PowerCage HDMI Rx, or a
PowerCage FOX DVI Plus Rx.
Plus mode disabled allows the output of the transmitter to be received by any FOXBOX,
PowerCage FOX, and FOX 500 VGA and DVI unit, including the Plus and non-Plus units.
Video Bit Depth panel
NOTE: The
Video Bit Depth
if you are connected to the receiver.
The radio buttons allow you to force the bit depth to 8 bits or to set it to
Video Bit Depth
auto.
Advanced tab functions
Click the tab to access the functions described below.
Advanced
NOTE: The Advanced functions are available only if you are connected to the receiver.
Figure 22. Advanced Tab
Link 2 and Daisy Chain radio buttons
Select among the
Enable Link 2
radio buttons to define the function of the receiver Tx LC connector;
Chain
either:
Routing RS-232 over fiber to the transmitter
•
• No function
• Routing the signal received on the Rx LC connector to the next receiver in a daisy chain
NOTE: The disable return link function is primarily used and recommended when the
transmitting device is a FOX 500 DA6 and the receiver is connected to any of outputs
2 through 6 on the FOX DA.
radio buttons are available
radio buttons allow you to enable and disable Plus mode.
panel radio buttons are available only
, , and
Disable Link 2 Enable Daisy
FOXBOX Tx/Rx HDMI • Remote Control 34