Extron electronics FOXBOX Tx HDMI User Manual page 38

Figure 18. FOX Extenders Control Program Window
NOTES:
• Figure 16 is an amalgam of program displays. Some controls and displays are
available when connected to the transmitter only and some when connected to
the receiver only. These functions are identified in the descriptions that follow.
•
Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for
serial command transmission. But, if you connect only one fiber optic cable,
the transmitter will not receive reports from the controlled device. For the
transmitter to receive responses from the controlled device, you must install
two fiber optic cables and leave link 2 enabled (via an
page 25) to the receiver or using the
page 34).
SIS command
FOX Extenders Control Program
FOXBOX Tx/Rx HDMI • Remote Control
(see
(see
30