Using The Program - Extron electronics FOXBOX Tx HDMI User Manual

Using the Program

Status panel
Figure 19.
The
Status
• HDMI indicator — This indicator is green when the transmitter detects a sync signal
on its HDMI video input
• Audio indicator — This indicator is green when the transmitter detects a low level
audio signal for a short period. This indicator goes dark if the audio signal drops below
the minimum threshold for a short period.
• Link 1 indicator — This indicator is green when the receiver detects light on the fiber
optic cable connected to the Tx port.
NOTE: The receiver detects the transmitter-Tx-to-receiver-Rx light. It reports the
status to the transmitter via the optional Rx cable.
If the PC is connected to the transmitter and either the secondary (receiver-
Tx-to-transmitter-Rx) cable is not connected in your system or the receiver
is in the daisy chain mode, the Link 1 indicator in the control program
does not show green (detected), whether the receiver detects the link or not.
• Link 2 (Optional) indicator — This indicator is green when the transmitter detects light
on the fiber optic cable connected to the Rx port.
NOTE: The transmitter detects the receiver-Tx-to-transmitter-Rx light. It reports the
status to the receiver via the Tx cable.
If the PC is connected to the receiver and either the primary (transmitter-Tx-to-
receiver-Rx) cable is disconnected or the receiver is in the daisy chain mode, the
Link 2 indicator in the control program will not show green (detected), whether the
transmitter detects the link or not.
The
Status
FOXBOX model (multimode or singlemode), the internal temperature, and the
video input frequency. The
FOXBOX HDMI.
Status Panel
panel provides indications of the connection status.
panel also shows to which unit the controlling PC is connected, the
Other side
entry cannot be read when connected to a
FOXBOX Tx/Rx HDMI • Remote Control 31