Extron electronics FOXBOX Tx HDMI User Manual page 18

Fiber optic connectors and LEDs
Q
WARNING:
which may be harmful to the eyes; use with caution.
AVERTISSEMENT :
continu qui peut être dangereux pour les yeux, à utiliser avec précaution.
• Do not look into the rear panel fiber optic cable connectors or into the fiber
optic cables themselves.
• Ne regardez pas dans les connecteurs de câble fibre optique sur le panneau
arrière ou dans les câbles fibre optique eux-mêmes.
• Plug the attached dust caps into the optical transceivers when the fiber cable is
unplugged.
• Branchez les protections contre la poussière dans l'ensemble émetteur/
récepteur lorsque le câble fibre optique est débranché.
NOTES:
•
You can connect the transmitter to one or more receivers in one of three ways:
• One way (transmitter-Tx-to-receiver-Rx) only — Connect fiber cable
(from transmitter connector
• Two way (transmitter to receiver and return) — Connect fiber cable
(from transmitter connector
(connector
2
• One way (transmitter to receiver) with daisy
chain (receiver to receiver) — Connect fiber
cable from a fiber optic source and cable
3
the next receiver in the daisy chain. See figure 6. Set
each receiver in the daisy chain to daisy chain mode Up
to 10 properly-configured receivers can be connected
in a daisy chain to a single transmitter.
• See the transmitter fiber connector
which also apply to these connectors.
3 3
Receiver
From Transmitter
or Daisy-Chained
4 4
Receiver
Figure 6. Daisy Chain Configuration
Rx (required) — For all one-way video, audio, and serial communications from the
1
transmitter to the receiver, connect a fiber optic cable to the Rx LC connector.
Connect the free end of this fiber optic cable to the Tx connector on the FOXBOX Tx
transmitter (item
F
Tx (optional) — Connect a fiber optic cable to the Tx LC connector for either of
2
the following functions:
Normal configuration — For all one-way return serial communications from the
receiver to the Rx connector on the transmitter. See figure 5.
Daisy chain configuration — For daisy-chained video, audio, and serial
communications to the Rx connector on another receiver. See figure 6.
NOTE: The Tx connector emits light in either case and the Rx port receives
light.
(see figure 4 on the previous page) —
The FOXBOX Tx/Rx HDMI outputs continuous invisible light,
Le FOXBOX Tx/Rx HDMI émet une lumière invisible en
) only.
1
) and fiber cable
1
). See figure 5.
NOTES on page 7,
3 3
Receiver
on page 7) or to any other compatible Extron FOXBOX device.
FOXBOX Tx/Rx HDMI • Installation
back to the transmitter
4
Tx Rx
to
4
4 4 3 3
Receiver
3 3 4 4
Transmitter
Tx Rx
1 1
(
on
page 7)
Figure 5. Two Way
Configuration
3
3
2 2
(
on
page 7)
10