Pnp/Pci Configuration Setup - AXIOMTEK SHB100 User Manual

SHB100 LGA775 SBC User's Manual

Power On function
Pressing this BIOS setting could helps you and power on the system by KB/Mouse
 PWN After PWR-Fail
This item specifies whether your system will reboot after a power failure or interrupt occurs.
Available settings are:. Off. Leaves the computer in the power off state.
5.10

PnP/PCI Configuration Setup

This section describes the configuration of PCI (Personal Computer Interconnect) bus system,
which allows I/O devices to operate at speeds close to the CPU speed while communicating
with other important components. This section covers very technical items that only
experienced users could change default settings.
 PNP OS Installed
If all your operating systems support Plug & Play (PnP), select Yes so that they can take over
the management of device resources. If you are using a non-PnP-aware OS or not all of the
operating systems you are using support PnP, select No to let the BIOS handle it instead.
Note that Windows 2000 will work with ACPI even with PnP OS Installed set to Enabled. Just
make sure you disable Advanced Power Management (APM) If all your operating systems
support Plug & Play (PnP), select Yes so that they can take over the management of device
resources. If you are using a non-PnP-aware OS or not all of the operating systems you are
using support PnP, select No to let the BIOS handle it instead.
Windows 2000 will work with ACPI even with PnP OS Installed set to Enabled. Just
make sure you disable Advanced Power Management (APM)
Note
48
.
PHOENIX-AWARD BIOS Utility