Table of Contents
Advertisement
SBC86831 Series All-In-One Mini ITX Board User's Manual
4.10 PnP/PCI Configuration Setup
This section describes the configuration of PCI (Personal Computer
Interconnect) bus system, which allows I/O devices to operate at
speeds close to the CPU speed while communicating with other
important components. This section covers very technical items that
only experienced users could change default settings.
Init Display First
This item allows you to decide to active whether PCI Slot or AGP
first. The options available are PCI Slot, AGP.
Reset Configuration Data
Normally, you leave this item Disabled. Select Enabled to reset
Extended System Configuration Data (ESCD) when you exit Setup
or if installing a new add-on cause the system reconfiguration a
serious conflict that the operating system can not boot. Options:
Enabled, Disabled.
Resources Controlled By
The Award Plug and Play BIOS can automatically configure all boot
and Plug and Play-compatible devices. If you select Auto, all
interrupt request (IRQ), DMA assignment, and Used DMA fields
disappear, as the BIOS automatically assigns them. The default
value is "Manual".
IRQ Resources
When resources are controlled manually, assign each system
interrupt to one of the following types in accordance with the type of
devices using the interrupt:
1. Legacy ISA Devices compliant with the original PC AT bus
Award BIOS Utility
61
Advertisement
Table of Contents
