Tool List - Siemens SINUMERIK 840D sl Operating Manual

Tool management

9.5 Tool list

9.5 Tool list
9.5.1 Tool list
All parameters and functions that are required to create and set up the tools are displayed in
the tool list.
Each tool is uniquely identified by the tool identifier and the replacement tool number.
Tool parameters
Column heading
Location
BS
* If activated in magazine
selection
Type
Tool name
ST
D
Length
Radius
Tip angle or
Pitch
180
Meaning
Magazine/location number
The magazine location numbers
•
The magazine number is specified first, followed by the location
number in the magazine.
If there is only one magazine, only the location number is displayed.
Load position in the load magazine
•
The following icons can also be displayed for other magazine types (e.g.
for a chain):
Spindle location as an icon.
•
• Locations for gripper 1 and gripper 2 (applies only when a spindle with
dual gripper is used) as icons.
Tool type
Specific tool offset data is displayed depending on the tool type
(represented as an icon).
You have the option of changing the tool type using the<SELECT> key.
The tool is identified by the name and the replacement tool number. You
may enter the names as text or numbers.
Replacement tool number (for replacement tool strategy)
Cutting edge number
Tool length
Geometry data, length
Tool radius
Tip angle for Type 200 - twist drill and Type 220 - centering tool and Type
230 countersink
Pitch for Type 240 - tap
Operating Manual, 03/2010, 6FC5398-6AP10-4BA0
Universal