Tool Wear - Siemens SINUMERIK 840D sl Operating Manual

9.6

Tool wear

All parameters and functions that are required during operation are contained in the tool
wear list.
Tools that are in use for long periods are subject to wear. You can measure this wear and
enter it in the tool wear list. The controller then takes this information into account when
calculating the tool length or radius compensation. This ensures a consistent level of
accuracy during workpiece machining.
You can automatically monitor the tools' working times via the workpiece count, tool life or
wear.
In addition, you can disable tools when you no longer wish to use them.
Tool parameters
Column heading
Location
BS
* If activated in magazine
selection
Type
Tool name
ST
D
Δ Length
Δ Radius
T C
Universal
Operating Manual, 03/2010, 6FC5398-6AP10-4BA0
Meaning
Magazine/location number
The magazine location numbers.
•
The magazine number is specified first, followed by the location
number in the magazine.
If there is only one magazine, only the location number is displayed.
Load position in the load magazine
•
The following icons can also be displayed for other magazine types (e.g.
for a chain):
Spindle location as an icon.
•
Locations for gripper 1 and gripper 2 (applies only when a spindle
•
with dual gripper is used) as icons.
Tool type
Depending on the tool type (represented by an icon), certain tool offset
data is enabled.
The tool is identified by the name and the replacement tool number. You
can enter the name as text or number.
Replacement tool number (for replacement tool strategy).
Cutting edge number
Length wear
Radius wear
Selection of tool monitoring
- by tool life (T)
- by count (C)
- by wear (W)
The wear monitoring is configured via a machine data item.
Please refer to the machine manufacturer's instructions.
Tool management
9.6 Tool wear
189