Siemens SINUMERIK 840D sl Operating Manual page 146

Multi-channel view
6.3 Setting the multi-channel view
Example
Your machine has 6 channels.
You configure channels 1 - 4 for the multi-channel view and define the display sequence
(e.g. 1,3,4,2).
In the multi-channel view, for a channel switchover, you can only switch between the
channels configured for the multi-channel view; all others are not taken into consideration.
Using the <CHANNEL> key, advance the channel in the "Machine" operating area - you
obtain the following views: Channels "1" and "3", channels "3" and "4", channels "4" and "2".
Channels "5" and "6" are not displayed in the multi-channel view.
In the single-channel view, toggle between all of the channels (1...6) without taking into
account the configured sequence for the multi-channel view.
Using the channel menu, you can always select all channels, also those not configured for
multi-channel view. If you switch to another channel, which is not configured for the
multiview, then the system automatically switches into the single-channel view. There is no
automatic switchback into the multi-channel view, even if a channel is again selected, which
has been configured for multi-channel view.
Procedure
146
1. Select the "Machine" operating area.
2. Select the operating mode "JOG", "MDA" or "AUTO".
3. Press the menu forward key and the "Settings" softkey.
4. Press the "Multi-channel view" softkey.
The "Settings for multi-channel view" window is opened.
5. Set the multi-channel or single-channel view and define which
channels are to be seen in the "Machine" operating area - and in the
double editor - in which sequence.
Operating Manual, 03/2010, 6FC5398-6AP10-4BA0
Universal