Side Views - Siemens SINUMERIK 840D sl Operating Manual

Simulating machining
5.5 Different views of a workpiece
Changing the display
You can increase or decrease the size of the simulation graphic, move it, turn it, or change
the segment.
Displaying and moving cutting planes
You can display and move cutting planes X, Y, and Z.
See also
Enlarging or reducing the graphical representation (Page 136)
Panning a graphical representation (Page 137)
Rotating the graphical representation (Page 138)
Modifying the viewport (Page 139)
Defining cutting planes (Page 140)
5.5.3

Side views

Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as
change the segment.
132
1. Starting the simulation.
2. Press the "Other views" softkey.
3. Press the "From front" softkey if you wish to view the workpiece from
the front.
- OR -
Press the "From rear" softkey if you wish to view the workpiece from
the rear.
- OR -
Press the "From left" softkey if you wish to view the workpiece from
the left.
- OR -
Press the "From right" softkey if you wish to view the workpiece from
the right.
Operating Manual, 03/2010, 6FC5398-6AP10-4BA0
Universal