Mount D8-4 Inside The Receiver - Tele Radio D8-2 Installation Instructions Manual

Chapter 3: PRODUCT PAGES

MOUNT D8-4 INSIDE THE RECEIVER

WARNING! The receiver must NOT be opened by any other than a qualified installer. Make sure to
turn the electricity off before opening the receiver.
WARNING! Do not touch the area marked with danger when the receiver has been powered by
electricity. Touching the marked area may be very hazardous.
NOTE! D8-4 analogue output module can only be mounted inside the Tiger MX receiver.
1. Remove the display board by unscrewing the five screws and lifting it up. If a relay expansion
board is mounted, it has to be removed first.
Danger! High Voltage
15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60
SR1 SR2 sF1 sF2
2. Mount the D8-4 unit on the display board with the four spacers. The screws are placed on the
back.
Danger! High Voltage
3. Put the display board back in the receiver using the five screws.
sF2
1 2 3 4 5
- 7 -
SYSTEM SETUP>
>Register TX
9
6 7 8 10
60
12
11