Switch And Jumper Settings; System Configuration Switch Settings - Dell PowerEdge C6145 Hardware Owner's Manual

Switch and Jumper Settings

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.

System Configuration Switch Settings

The function of system configuration switch installed on each system board
is shown below:
Figure 5-16. System Configuration Switch
Table 5-1. System Configuration Switch
Jumper Function
SW 1 NVRAM Clear
SW 2 System Reset
SW 3 Clear Password Enable
SW 4 BMC NMI Enable
NOTE: The * in the table of system configuration jumper describes the default
status and the default state is not active state.
242 | Jumpers and Connectors
Off On
*Disable Enable
*Disable Enable
*Disable Enable
*Disable Enable