Printronix ThermaLine T5000r User Manual page 97

A
Adjusting the scanning beam, 27, 33
Auto detect bar codes, 50, 78
Auto Report, 45
Auto Report Time, 46
Average BWD, 49
B
Bad bar codes, 78
Bar Code Demo Page, 36
Bar code fails / Job has errors, 86
Bar code failure, 78
Bar code grading, 57
Bar Code Improper / Data Format, 86
Bar code quiet / zone too small, 87
Bar codes supported, 11
Bar width deviation, 49, 55
Beam adjustment, 27
Beam Shift, 72
Beam shifting, 33
Beam Width, 71
BWD, 49
C
Calibration / warning, 87
Calibration, setting, 34
Checksum Failure, 87
Clear Data, 47
Clear validator data, 47
Index
Configuring, 44
Contact information, 95
Contrast too low / Check media, 88
Customer Support Center, 95
Decodeability, 55
Defects, 56
Demo Page, 36
Disabling validator, 44
EC Min, 59
Enabling the validator, 26
Enabling validator, 45
Error action, 79
Grade&Report, 83
Overstrike Mode, 81
Rescan Form, 83
Rescan&Retry, 84
Rescan&Stop, 84
Retry Form, 82
Stop Mode, 81
Stop & Retry, 82
Error messages, 86
Bar code fails / Job has errors, 86
Bar Code Improper / Data Format, 86
Bar code quiet / zone too small, 87
Calibration / warning, 87
Checksum Failure, 87
D
E
97