Printronix ThermaLine T5000r User Manual page 17

RJ-11 Connector
(to validator)
Figure 3. Wrapping the Power/Data Cable Around the Ferrite
3. Using the RJ-11 connector end of the power/data cable, insert
4. Wrap the power/data cable around the ferrite twice.
5. Adjust the position of the ferrite so that the length from the
Power/Data Cable
Second Wrap
20.0 ± 0.5
inches
the cable through the ferrite. (Figure 3.)
ferrite to the RJ-11 connector is 20 ± 0.5 in
Install The Ferrite
Ferrite
Wide P10 Connector
(to controller board)
Power/Data Cable
First Wrap
.
ches
17