Printronix ThermaLine T5000r User Manual page 84

Chapter 2
Bar Code Failures
Rescan&Retry
This mode is similar to Rescan Form with one exception: after the
printer has rescanned the form and overstruck it if there was still a
fault, it will reprint and rescan the same form again.
NOTE: The number of times the printer will attempt to rescan the
If the printer scans these forms correctly on any of the rescans or
reprints, it will continue printing with the next form.
If the printer fails to scan these forms correctly on all of the rescans
and reprints, it will overstrike the forms, stop, and indicate an error
similar to Stop mode. After you clear the error message, the printer
will skip a number of blank labels, depending on the setting for Skip
Labels (see "Setting For Skip Labels" on page 52).
It will then slew to the next top of a blank form and reprint the same
form or go the next form, depending on the setting for Max Retry
Action (see "Max Retry Action" on page 54).
Rescan&Stop
This mode is similar to the Retry Form mode, however, instead of
backing up and overstriking the form, the printer will back up and
rescan the bad form and any other forms that have already printed
(see "Forms Printed After an Error Detection" on page 80).
NOTE: The number of times the printer will attempt to rescan the
If the printer scans these forms correctly on any of the rescans, it
will continue printing with the next form.
If the printer fails to scan these forms correctly on all of the rescans,
it will stop and indicate an error similar to Stop mode. After you
clear the error message, the printer will skip a number of blank
labels, depending on the setting for Skip Labels (see "Setting For
Skip Labels" on page 52).
84
form is determined by the Num Rescan setting. See "Num
Rescan" on page 54.
The number of times the printer will attempt to reprint the
bad form is determined by the Num Retry setting. See
"Num Retry" on page 54.
form and following forms is determined by the Num Rescan
setting. See "Num Rescan" on page 54.