Printronix ThermaLine T5000r User Manual page 83

Grade&Report
In this mode, the entire print job will print uninterrupted. If one or
more errors is detected, the printer status indicator lamp flashes,
the alarm sounds, and the error message "Bar code fails / Job has
errors" displays.
IMPORTANT
The error message lets you know that at least one bad form
printed. To determine which form(s) are bad, you must
manually scan all of them.
The printer remains in a fault condition until you press the PAUSE
key. This clears the error message and takes the printer offline.
Correct any condition that may have caused the fault, then press
PAUSE to place the printer back online.
Rescan Form
This mode is similar to the Retry Form mode, however, instead of
backing up and overstriking the form, the printer will back up and
rescan the bad form and any other forms that have already printed
(see "Forms Printed After an Error Detection" on page 80).
NOTE: The number of times the printer will attempt to rescan the
If the printer scans these forms correctly on any of the rescans, it
will continue printing with the next form.
If the printer fails to scan these forms correctly on all of the rescans,
it will overstrike the forms, stop, and indicate an error similar to Stop
mode. After you clear the error message, the printer will skip a
number of blank labels, depending on the setting for Skip Labels
(see "Setting For Skip Labels" on page 52).
It will then slew to the next top of a blank form and reprint the same
form or go the next form, depending on the setting for Max Retry
Action (see "Max Retry Action" on page 54).
NOTE: The only difference between Rescan Form and
form and following forms is determined by the Num Rescan
setting. See "Num Rescan" on page 54.
Rescan&Stop is that when a form still fails after all the
rescans, Rescan Form will overstrike the bad form,
whereas Rescan&Stop will not.
Error Action
83