Printronix ThermaLine T5000r User Manual page 46

Chapter 2
Configuring The Validator
You can determine the end of a batch job in two ways:
by using an Execute command, or
•
by enabling the Auto Report Time (see below).
•
To enable Auto Report:
1. Press
Menu mode.
2. If necessary, press ↓ and
↵
3. If necessary, press
4. Press ↓ until Auto Report displays.
5. Press + or – to scroll through the choices: Enable or Disable.
The default is Disable.
6. When Enable displays, press
7. Press ↓ and
PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
Setting Auto Report Time
This function allows you to set, in seconds, the timeout for the Auto
Report. If the printer is idle for the set number of seconds, an Auto
Report will be generated if Auto Report is set to Enable (see
"Setting Auto Report" on page 45.) The default is 1 second.
To set the Auto Report Time:
1. Press
Menu mode.
2. If necessary, press ↓ and
↵
3. If necessary, press
4. Press ↓ until Auto Report Time displays.
5. Press + or – to scroll through the choices: 1 to 10 seconds. The
default is 1 second.
6. When the desired number of seconds displays, press
the Auto Report Time.
46
. .
to take the printer offline and place the printer in
.
↵
key.
. .
until VALIDATOR displays.
.
↵
at the same time to lock the
. .
to take the printer offline and place the printer in
.
↵
key.
. .
until VALIDATOR displays.
.
at the same time to unlock the
↵
to activate Auto Report.
↵
key, then press
at the same time to unlock the
↵
to set