Beam Shift - Printronix ThermaLine T5000r User Manual

Chapter 2
Configuring The Validator

Beam Shift

This option enables you to shift the scanning beam horizontally to
the left or right. The left edge of the beam should be approximately
0.13 inches (3.3 mm) from the left edge of the tear bar. After you
set this value, save it as part of the configuration for future use.
The value range is from –99 to 99. The default is 0. Lower values
will move the beam to the left.
1. Press
2. If necessary, press ↓ and
3. If necessary, press
4. Press ↑ until Beam Shift displays.
5. Press + or – to scroll through the values: –99 to 99. The default
6. Save the configuration for future use.
72
. .
to take the printer offline and place the printer in
.
Menu mode.
↵
key.
. .
until VALIDATOR displays.
.
is 0. Lower values will move the beam to the left. Press
accept the shift value.
Keep selecting the new value until the beam width is at the
desired position. The left edge of beam should be
approximately 0.13 inches (3.3 mm) from the left edge of the
tear bar.
↵
at the same time to unlock the
↵
to