Printronix ThermaLine T5000r User Manual page 64

Chapter 2
Configuring The Validator
validator when printing at the set Print Speed (in the QUICK SETUP
and MEDIA CONTROL menus). This is because the on-demand
printing portion is done at a fixed print speed which may be higher
or lower than the set Print Speed. For example, a bar code printed
at 7 ips may yield eight Total Scans, but if printed in an on-demand
printing mode it may yield 18 Total Scans.
Scan Report Information
1. "ERROR:" followed by highest priority failure message (if an
error other than "Unscannable Code" occurred) or "None" if no
error occurred
2. Printout of characters read from the bar code
3. Symbology Type Read (e.g. Code 39, Code 128, etc.)
4. Overall Grade (letter grade and calculated/number value)
5. X dimension (mils)
6. Decodeability (%)
7. Modulation (%)
8. Symbol Contrast (%)
9. EC (Average Edge Contrast) (%)
10. Defects (%)
11. Rmin/Rmax (reflectance min/max)
12. PCS (Print Contrast Signal)
13. Percent Decode (%)
14. Bar Deviation Avg (%)
15. Min. Bar Deviation (%)
16. Max. Bar Deviation (%)
17. Ratio
18. Good Scans
19. Total Scans
64