Adjust The Scanning Beam; Continuous, Tear-Off, And Tear-Off Strip - Printronix ThermaLine T5000r User Manual

Adjust The Scanning Beam

NOTE: Make sure the printer is on and the scanning beam is on. If

Continuous, Tear-Off, and Tear-Off Strip

When the validator is first installed, the scanning beam may need to
be aligned with the two notches on the sides of the tear bar, as
shown in Detail A of Figure 11. When the scanning beam is
properly aligned it will line up with the two notches.
Figure 11. Aligning the Scanning Beam: Continuous, Tear-Off, and Tear-Off Strip
Continuous, Tear-Off, and Tear-Off Strip
the beam is off, press the RESET button for less than 2
seconds to turn on the beam.
Scanning Beam
A
Media Handling Modes Only
A
Notch in Tear Bar
t 5 l s r l c 2
J u n e 1 9 , 2 0 0 0
27