When set to Enable (the default), then the bar code quiet zone is
included as part of the pass/fail criteria.
. .
1. Press
to take the printer offline and place the printer in
.
Menu mode.
2. If necessary, press ↓ and
↵
key.
. .
3. If necessary, press
.
4. Press ↓ until Quiet Zones displays.
5. Press + or – to scroll through the choices: Enable or Disable.
The default is Enable.
↵
6. Press
to select the desired value.
↵
7. Press ↓ and
at the same time to lock the
PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
NOTE: The validator does not recognize x-dimensions greater
than 40 mil with Quiet Zones enabled.
Checking The Firmware Revision Number
For troubleshooting purposes, you may need to reference the
firmware revision number.
. .
1. Press
to take the printer offline and place the printer in
.
Menu mode.
2. If necessary, press ↓ and
↵
key.
. .
3. If necessary, press
.
4. Press ↓ until F/W Revision displays. The firmware revision
number displays.
↵
5. Press ↓ and
at the same time to lock the
PAUSE to take the printer offline.
6. Press PAUSE again to put the printer online.
Defining Validator Options
↵
at the same time to unlock the
until VALIDATOR displays.
↵
key, then press
↵
at the same time to unlock the
until VALIDATOR displays.
↵
key, then press
51