Printronix ThermaLine T5000r User Manual page 23

Validator
(Rear View)
Validator
(Front View)
Bracket
Outside
Adjustment
Screw
Figure 9. Installing the Validator/Upper Bracket Unit onto the Lower Bracket
2. Face the front of the printer while installing the validator/upper
bracket unit.
3. Loosen the outside adjustment screw and remove the inside
adjustment screw on the bottom of the validator.
4. Slide the validator/upper bracket unit onto the lower bracket and
align the hash marks with the alignment screw accordingly.
NOTE: Refer to Figure 9, Detail A for location of the validator hash
5. When the unit is positioned correctly, tighten the outside
adjustment screw on the validator to lock the unit into place.
Hash
Marks
Alignment
Screw
Lower
Bracket
Upper
Inside
Adjustment
Screw
mark for each printer model size. The printer model size is
also inscribed on the lower bracket.
Install The Brackets
A
4 in. 6 in. 8 in.
Printer
A
23