Printronix ThermaLine T5000r User Manual page 67

Profile H Mag
This menu item selects the horizontal magnification for printing the
scan profile. This allows you to zoom in on the profile. Magnification
values are multiples of the scan profile length printed for a given
Beam Width setting. For example, if the Beam Width setting of
1800 prints a 4 inch scan profile, a Profile H Mag setting of 2 prints
an 8 inch scan profile.
You can set the Profile H Mag parameter to a value from 1 to 4.
The default is 1.
. .
1. Press to take the printer offline and place the printer in
.
Menu mode.
2. If necessary, press ↓ and
↵
key.
. .
3. If necessary, press
.
4. Press ↑ until Profile H Mag displays.
5. Press + or – to scroll through the values: 1 to 4. The default is 1.
↵
6. Press to select the desired value.
↵
7. Press ↓ and
at the same time to lock the
PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
Figure 18 shows a Profile H Mag setting of 2 for the same scan
profile shown in Figure 17, page 66 (Profile H Mag setting of 1).
Figure 18. Sample Scan Profile: Profile H Mag = 2
Advanced Validator Options
↵
at the same time to unlock the
until VALIDATOR displays.
↵
key, then press
67