Remotely Rebooting The Ap - Ruckus Wireless ZoneFlex 7781CM Installation Manual

Figure 27. Location of the reset button
4. Using a pen or a similar pointed object, momentarily press the reset button on the
reset adapter assembly to reboot the AP and CM, or hold the reset button for
10 seconds to reset the AP and CM to factory defaults.
The LEDs briefly turn off when the 7781CM reboots. When the far-right green LED
comes on, the 7781CM has completed the reboot process.
5. Replace the Reset Button blanking cap.
You have completed resetting the AP and CM to their factory default settings and/or
rebooting the AP and CM.

Remotely Rebooting the AP

NOTE: The AP part of the 7781CM can be remotely rebooted, but Ruckus Wireless does
not recommend that the CM be remotely rebooted, as the AP communicates with the
administrative computer through the CM.
NOTE: Before starting this procedure, you must first obtain the related MIBs from Ruckus
Wireless. Contact your authorized Ruckus Wireless sales representative or Ruckus Wireless
Support. Visit http://support.ruckuswireless.com/contacts for Ruckus
Wireless Support contact information.
1. Connect the administrative computer to the same network as the 7781CM.
2. Start your MIB browser.
3. Load the Ruckus Wireless MIBs onto the MIB browser.
Appendix B: Rebooting and Resetting the 7781CM
Reset Button
59