Rebooting The Ap And Cable Modem - Ruckus Wireless ZoneFlex T301s User Manual

Rebooting the AP and Cable Modem

You can use the Web interface to prompt the AP to reboot, which restarts the AP
without changing any of the current settings. If your AP is equipped with an integral
Cable Modem (such as a 7781CM), then you can use the AP Web interface to
prompt the CM to reboot, which restarts the CM without changing any of the current
settings.
Please note that rebooting the AP or CM disrupts network communications in any
currently active WLANs.
1 Go to Maintenance > Reboot/Reset. The Maintenance > Reboot/Reset page
appears.
2 To reboot the AP, click Reboot AP with current settings/Reboot Now. After a
brief pause, you are logged out of the AP.
3 To reboot the CM, click Reboot Cable Modem/Reboot Now. After a brief pause,
you are logged out of the AP.
Figure 57. The Maintenance > Reboot/Reset page
After approximately one minute, you should be able to log back into the AP, which
verifies that the reboot was successful. You can also check the LEDs on the AP to
verify the status of the device.
NOTE The 7781CM AP with integral cable modem can also be remotely reset using
the OID and CLI commands described in the ZoneFlex 7781CM Installation Guides.
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A
Rebooting the AP and Cable Modem
Scheduling Automatic Upgrades
138