Using The Ap's Web Interface To Switch Leds To Cm Mode - Ruckus Wireless ZoneFlex 7781CM Installation Manual

Operating and Troubleshooting the 7781CM
Switching LEDs to CM Mode

Using the AP's Web Interface to Switch LEDs to CM Mode

This procedure is only available if the AP is in standalone mode.
1. Log in to the AP's Web interface as described in
via CMTS"
2. On the menu, click Administration > LED Diagnostics.
Figure 26.
3. In LED Mode, click one of the following modes:
• (1) Cable Modem: Click this option if you want the LEDs to stay in CM Mode until
you switch them to another mode.
• (3) Alternate between modes 1 and 2 at 30 second period then disabled after
60 minutes: Click this option if you want the LEDs to switch to CM Mode as soon
as you click Save, and then alternate with AP Mode every 30 seconds.
4. Click Save.
5. Check the access point for a white LED. This indicates that the LEDs are now in CM
Mode.
NOTE: If you see a far-right green LED, this indicates that the LEDs are still in AP Mode.
You have completed switching the LEDs to CM Mode using the access point's Web
interface.
50
on page 48.
The LED Diagnostics page
"Logging Into the AP's Web Interface