Associating A Wireless Client With The Ap - Ruckus Wireless ZoneFlex 7781CM Installation Manual

Associating a Wireless Client with the AP

1. In the client device's wireless interface, select the SSID configured in
Wireless # Settings"
2. Connect the client device to the selected WLAN SSID.
After the wireless client successfully connects to the wireless LAN, continue with
the TR069 Status (FlexMaster Management Only)"
from the Power Source and Administrative Computer"
Checking the TR069 Status (FlexMaster Management
Only)
If you configured the AP to report to a FlexMaster server on the network
FlexMaster Server Address (Optional)"
can successfully communicate with the FlexMaster server. You can do this by checking the
TR069 status on the AP's web interface.
1. In the AP's web interface, go to the Administration > Management page.
2. Scroll down to the TR069 Status section.
3. Check the value for Last successful contact. If it shows a date in green, then the AP
was able to communicate successfully with FlexMaster.
Continue with "Disconnecting the AP from the Power Source and Administrative
Computer" on page 38.
Preparing the 7781CM at the Depot and Shipping to the Field
on page 33.
on page 34), then make sure you verify that the AP
Verifying AP Operation
"Configuring
on page 37 or "Disconnecting the AP
on page 38.
("Setting the
"Checking
37