Step 5: Attaching The Ap Bracket To The Linkage Bracket - Ruckus Wireless Q910 User Manual

Physical Installation of Q910 LTE Access
Point Mounting Instructions
FIGURE 7 Attaching the linkage bracket to the U-joint bracket
2. Set the azimuth required by AP.
3.
Tighten the M8 bolt to 13.6 N-m (10 ft-lbs.)
4. Continue with

Step 5: Attaching the AP Bracket to the Linkage Bracket

Step 5: Attaching the AP Bracket to the Linkage Bracket
Attach the AP bracket to the linkage bracket using the included bolt, nut, lock washer, flat washer, serrated external tooth washer shown
in below figure.
The AP bracket attaches to the linkage bracket using an M8 bolt and washer set. The linkage bracket is symmetrical, and either end can
be attached to the AP bracket.
NOTE
Make sure that linkage bracket is installed with its serrated external-tooth lock washer on the inside of the AP bracket
flanges. This ensures that the elevation adjustment does not change.
As described in Step 4: Mounting the Linkage Bracket to the U-Joint Bracket
bracket, the second serrated external-tooth lock washer, and the second M8 bolt and washer set.
18
on page 14.
on page 11, loosely assemble the AP bracket, the linkage
Q910-US00 User Guide
Part Number: P01-Q910-US00