Remotely Rebooting The Ap - Ruckus Wireless ZoneFlex 7761-CM Installation Manual

Remotely Rebooting the AP

Using the Reset Shunt
15
Remotely Rebooting the AP
NOTE:: The AP can be remotely rebooted, but it Ruckus Wireless does not recommend
that the CM be remotely rebooted, as the AP communicates with the administrative
computer through the CM.
NOTE: Before starting this procedure, you must first obtain the related MIBs from Ruckus
Wireless. Contact your authorized Ruckus Wireless sales representative or Ruckus Wireless
Support. Visit http://support.ruckuswireless.com/contacts for Ruckus
Wireless Support contact information.
You can use SNMP to reboot the AP:
1. Connect the administrative computer to the same network as the CMAP.
2. Start your MIB browser.
3. Load the Ruckus Wireless MIBs onto the MIB browser.
4. In the MIB browser, specify the IP address of the 7761-CM access point. (You can obtain
this information from the DHCP server on the network.)
5. Find the OID 1.3.6.1.4.1.25053.3.1.4.7.3 (ruckusZF7761CMControlLED).
6. Set the value to 14 (powerCycleAP).
You have completed remotely rebooting the access point using SNMP.
60