Using The Ap's Web Interface To Switch Leds To Cm Mode - Ruckus Wireless ZoneFlex 7761-CM Installation Manual

Switching LEDs to Cable Modem Mode

Using the AP's Web Interface to Switch LEDs to CM Mode

When the access point boots up, the LEDs are in CM Mode. Once it completes the bootup
process, the LEDs alternate between CM Mode and AP Mode. The LEDs are color-coded
to enable you to quickly identify the current LED mode:
If you see the far-right green LED, the LEDs are in AP Mode.
■
If you see a white LED, the LEDs are in CM Mode.
■
If you want the LEDs to stay in CM Mode, you need to manually switch them to CM Mode.
You can switch to CM Mode using either of the following methods:
Using the AP's Web Interface to Switch LEDs to CM Mode
■
Using SNMP to Switch LEDs to CM Mode
■
Using the AP's Web Interface to Switch LEDs to CM
Mode
This procedure is only available if the AP is in standalone mode.
1. Log onto the access point's Web interface.
2. On the menu, click Administration > LED Diagnostics.
3. In LED Mode, click one of the following modes:
• (1) Cable Modem: Click this option if you want the LEDs to stay in CM Mode until
you switch them to another mode.
• (3) Alternate between modes and 1 at 30 second period then disabled after
60 minutes: Click this option if you want the LEDs to switch to CM Mode as soon
as you click Save, and then alternate with AP Mode every 30 seconds.
4. Click Save.
5. Check the access point for a white LED. This indicates that the LEDs are now in CM
Mode.
NOTE: If you see a far-right green LED, this indicates that the LEDs are still in AP Mode.
You have completed switching the LEDs to CM Mode using the access point's Web
interface.
54