Table of Contents
Advertisement
Configuring the AP for Management by FlexMaster or for Standalone Operation
Connecting the AP to the Administrative Computer
1. Verify that the AP is powered on as described in
2. If you are powering the AP with PoE, then continue with
the AP with AC, then continue with
3. Connect one end of the Ethernet cable to the Data In port on the PoE injector.
4. Connect the other end of the Ethernet cable to the administrative computer either
directly or through a hub.
5. You have completed connecting the AP to the administrative computer. Continue with
" Logging In to the Access Point's Web Interface"
6. Connect one end of the Ethernet cable to the PoE IN port on the AP .
7. Connect the other end of the Ethernet cable to the administrative computer.
8. You have completed connecting the AP to the administrative computer. Continue with
" Logging In to the Access Point's Web Interface"
Logging In to the Access Point's Web Interface
1. In the address or location bar, type the following address:
https://192.168.0.1
2. Press <Enter> on the keyboard to connect to the AP's web interface. A security alert
message appears.
3. Click Yes or OK or Proceed anyway (depending on the browser) to continue. The AP's
login page appears.
Figure 11.
The ZoneFlex Access Point login page
4. In Username, type super .
5. In Password, type sp-admin .
6. Click Login . The web interface appears, displaying the Status > Device page.
7. Continue with
" Configuring Common Wireless Settings"
Preparing the SC8800-S AP at the Depot and Shipping to the Field
Step
6.
" Powering the AP"
on
Step
3. If you are powering
on
page
19.
on
page
19.
on
page
20.
page
14.
19
Advertisement
Table of Contents
