Table of Contents
Advertisement
RTS/CTS Delay
DTR Alarm Control
DTR Alarm Status
Format
Flow Control
Character Size
Parity
Stop Bit
Ethernet (IP Details) Screen
The Request To Send/Clear To Send parameter determines how long the unit
waits before it changes the level of CTS to match RTS when the CTS
parameter is set to "Internal."
Values: Normal (~30 ms delay), Long (~100 ms delay)
Default: Normal
Lets you set DTR Alarm Control parameters.
Values: Enable, Disable
Default: Disable
Lets you view the current DTR Alarm status.
Selects the port's operating mode.
Values: Sync, Async
Default: Sync
Selects the type of flow control to be used if the port is asynchronous.
Values: None, Xon/Xoff, RTS/CTS
Default: None
Selects the number of bits to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Selects the setting for the parity bit if the port is asynchronous.
Values: None, Odd, Even
Default: None
Selects the number of bits to end the character.
Values: 1, 2
Default: 1
Current Pin Status
The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Serial screen.
The 10/100 Ethernet (IP Service Details) screen (Figure 4.9) lets you
configure the IP parameters listed below.
V T 1 0 0 I n t e r f a c e
4-11
Advertisement
Table of Contents
