Table of Contents
Advertisement
FrameStart Delay
FrameStart Status
Remote DLCI
Remote Unit
Round Trip Delay Size
Round Trip Delay Rate
Status
Receiving FECN/
BECN
If this parameter is set to "Enable," the unit will send FrameStart discovery
and delay frames on this DLCI, and will report the state of the remote
Verilink FSx unit. It will also send SOS frames when the FRAD/router
connected to this unit goes inactive.
Values: Enable, Disable
Default: Enable if Auto Discovery is set to "Yes"; Disable otherwise
If the remote unit is a Verilink FSx product and FrameStart Auto Discovery is
enabled, the FrameStart Status field will show the status of the remote unit.
The status is "Active" if both the local and remote DLCIs are active and the
remote unit answers to the discovery frames sent by this unit. The status is
"SOS" if the remote unit is active but the FRAD/Router connected to it is
inactive. The status is "Inactive" in all other cases.
Values: Active, Inactive, SOS
Default: Inactive
If the remote unit is a Verilink FSx product, and FrameStart Auto Discovery
is enabled, this displays the DLCI number used on the remote end of this
DLCI.
Values: 16−1023
Default: 0
If the remote unit is a Verilink FSx product, and FrameStart Auto Discovery
is enabled, this parameter gives the first three digits of the unit ID configured
on the remote end of this DLCI.
Values: 000−999
Default: 000
Specifies the frame size (in bytes) of packets making the round trip. If the
Round Trip Delay Size is not configured, the Frame Relay Details values will
be used.
Specifies the rate (in seconds) at which Round Trip Delay packets are sent. If
the Round Trip Delay Rate is not configured, the Frame Relay Details values
will be used.
DLCI Status Table
The bottom portion of the screen shows a table detailing the actual status of and
alarm threshold information for the selected DLCI as follows:
If this DLCI is up, the status will be "Active"; otherwise, the status will be
"Inactive."
Values: Active, Inactive
Default: Inactive
When a frame is received with a congestion bit set, this parameter is set to
"Yes." It is set back to "No" when a frame is received without a congestion
bit set.
Values: Yes, No
Default: No
W e b S e r v e r I n t e r f a c e
3-33
Advertisement
Table of Contents
