Table of Contents
Advertisement
If this parameter is set, a PC connected to the LAN interface of this
WANsuite 5330 can reach a remote WANsuite 5330 through this DLCI. The
remote IP address must be part of an IP network that is different from the
local WANsuite 5330, and the local WANsuite 5330's IP address must be
configured as a gateway into the PC. This way, local and remote
WANsuite 5330s can be reached regardless of the availability of the routers
connected at the back of the WANsuite 5330s.
Values: IP address
Default: 0.0.0.0
Remote IP Mask
If the Remote IP Address is set, the Remote IP Mask must also be set.
Values: IP address
Default: 0.0.0.0
Type
If data received from this DLCI has to be switched to its corresponding
destination port, you must set the type to "Switched." Set the type to "Local"
if this DLCI will be used for management purposes only.
Values: Switched, Local
Default: Switched
Delete Endpoint
You may delete any endpoint.
Endpoint Service Details Screen
Selecting from the <Svc> column on the Endpoint Table screen displays the
typical Service Details screen in which you can view, and in some cases
change, parameters including Index, Interface, Type, and Pair. A "Delete
Service" prompt is also included on this screen.
DLCI Details Screen
The DLCI Details screen (Figure 4.21) lets you access the configuration
parameters described in the following paragraphs. To bring up this screen,
select any DLCI from the <DLCI> column on the Endpoint Table screen.
Figure 4.21
Endpoint DLCI Details Screen
V T 1 0 0 I n t e r f a c e
4-29
Advertisement
Table of Contents
