Table of Contents
Advertisement
Speed
Character Size
Parity
Stop Bit
DTR Alarm Control
DTR Alarm Status
Diagnostic Msgs
Figure 4.10
Supervisory Config Screen
The Supervisory screen lets you view and change the Supervisory port speed
used by PPP and VT100. The Supervisory port only supports asynchronous
character formats.
Changes the Supervisory port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 19200
Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Selects the parity bit if the port is asynchronous.
Values: None, Odd, Even
Default: None
Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
Setting DTR Alarm Control to "Enable" allows the unit to go into alarm on a
loss of DTR.
Values: Disable, Enable
Default: Disable
Indicates the current state of the DTR alarm.
Enables the Supervisory port to send out diagnostic messages upon power-up.
Values: Enable, Disable
Default: Enable
V T 1 0 0 I n t e r f a c e
4-13
Advertisement
Table of Contents
